Clicker requires WiFi connection to work. Since it doesn't have its own interface, you should use Panel to change WiFi settings. Here's how to do it.
Update! On 19th of July, 2026 we have released a new feature called "Update Firmware". It now makes WiFi changing process way easier. You can simply generate a new firmware for your Clicker in the Panel, then flash it yourself (no extra software needed). See the video below.
You can still use the old way of changing WiFi via "Setup Mode". It is described below. The "Setup Mode" has important limitation: it is NOT possible to use if Clicker connects to existing WiFi. Meaning, if it already works, you can't change it. Unless you change your WiFi's name/password or turn it off completely. That's because Clicker will never enter "Setup Mode" if it can already connect to WiFi successfully.
1. Connect Clicker to the PC. It should start blinking. Wait until it starts doing 1 blink every 5 seconds. It means that Setup Mode was entered.
2. Open Setup Mode page in Panel: round button at the bottom right corner of the screen.
3. Connect to the Device. Find it by Device ID in the browser pop up window.
4. Enter and save WiFi name and password. Check the logs and wait until you see "WiFi manager: WiFi test success". Now you can unplug Clicker and connect it to the iPhone.
After these steps Clicker will use the new WiFi configuration.